The most common MOT failures are lights and electrical faults, suspension, tyres and brakes. In DVSA data for 2025-26 covering cars and light vans (MOT classes 3 and 4), problems with lamps, reflectors and electrical equipment turned up in 10.44% of all tests, suspension in 8.90%, tyres in 6.23% and brakes in 6.10%. Across 33,310,534 tests, 27.51% failed first time and 22.30% still had a fail as the final result (DVSA MOT testing data for Great Britain, data set updated 10 September 2026, figures read 14 November 2026).
So roughly one test in four ends in a first-time fail, and much of what fails is cheap: a bulb, a worn tyre, a wiper blade. The trick is knowing which entries on a failure sheet are a ten-minute fix and which point to a car that’s been run down for years.
What fails an MOT most often: the DVSA numbers
The figures below give, for every car and light van test in 2025-26, the share that recorded at least one defect in each area. A single test can appear in more than one row.
| Area | Share of tests with a defect | Typical causes |
|---|---|---|
| Lamps, reflectors and electrical equipment | 10.44% | Blown bulbs, headlamp aim, number plate lamp, battery security |
| Suspension | 8.90% | Worn joints and bushes, broken springs, corroded mounting points |
| Tyres | 6.23% | Tread too low, cuts and bulges, mismatched sizes on one axle |
| Brakes | 6.10% | Worn pads and discs, poor efficiency on the roller test, warning lights |
| Visibility | 4.28% | Chips or cracks where the driver looks, wipers, washers, mirrors |
| Body and chassis | 3.23% | Corrosion near structural points, sharp edges |
| Noise, emissions and leaks | 3.08% | Exhaust smoke, engine warning light, fluid leaks |
One number stands out in the DVSA tables: tyres made up 60.60% of all dangerous defects. Lights fail more tests, but a bald tyre is the item most likely to be graded as an immediate danger.
What can fail an MOT? The rules behind the common items
The DVSA’s MOT inspection manual (last updated 14 October 2026, read 20 November 2026) sets the standard a tester applies. Here are the rules behind the failures you’re most likely to meet, with the grade the manual gives.
Tyres
On a car with up to eight passenger seats, the main grooves must be at least 1.6mm deep across the central three-quarters of the tread and around the whole circumference. Below that is a dangerous defect, not a major one. Tyres of different sizes on the same axle are a major defect, and radial and cross-ply tyres must never be mixed on one axle. The spare isn’t inspected.
Lights
Headlamp aim outside the limits, or aim that can’t be tested, is a major defect. So is a dead number plate lamp when the plate has only one lamp; with two or more lamps, one dead lamp is minor. The number plate lamps must also come on with the side lights. These cost the least to put right of anything on a failure sheet, and they’re the easiest to avoid: walk round the car with someone working the switches before the test.
Battery and wiring
A leaking battery is a major defect. A battery that’s loose but unlikely to fall is minor; one likely to fall or short out is major. Wiring insulation damaged badly enough to risk fire or sparks is dangerous. On electric and hybrid cars, the manual tells testers to inspect the batteries too, visually only where the traction battery can be reached, and to refuse the test if a battery is leaking.
Engine warning light
Petrol and hybrid cars on four wheels or more, first used since 1 July 2003, must show the engine malfunction light when the ignition comes on, and it must then go out. A light that stays lit, or never lights, is a major defect. It’s a common fail on older cars because the light often reports a sensor fault the owner has been ignoring.
Fluid leaks
Testers check for leaks on cars and vans. A leak that forms a pool more than 75mm across within 5 minutes fails. Coolant, screen wash and SCR fluid leaks are excluded from that rule. A continuous leak that’s a serious road safety risk is graded dangerous.
Diesel smoke
Where there’s no maker’s plate value, diesels first used on or after 1 January 2014 must stay under 0.7m-1 on the smoke test, and those from 1 July 2008 to the end of 2013 under 1.5m-1. Testers can decline the smoke test if running it might damage the engine.
Things you can check before the test
A ten-minute walk round before you book catches most of the cheap items. None of this replaces the test; it just stops you paying for a retest over a bulb.
- Every light. Headlamps on dip and main beam, side lights, indicators, hazards, brake lights, fog lamp, reversing lamp and both number plate lamps.
- Tyres. Look for cuts, bulges and uneven wear. Measure the tread in the middle three-quarters of each tyre with a gauge.
- Wipers and washers. Blades that smear or skip, a washer bottle that’s empty.
- Windscreen. Chips and cracks in the driver’s line of sight.
- Warning lights. Start the car and watch the dashboard: engine, airbag, ABS and brake lights should come on and go out.
- Horn, seatbelts and doors. Each belt should lock when tugged; each door should open from inside and out.
- Number plates. Clean, secure, legal characters and spacing.
- Under the car. Park on a clean dry surface for a few minutes and look for drips.
Suspension and brake wear are harder to judge at home. A clonk over bumps, or a pull to one side when braking, is reason enough to have a garage look before the test.
Reading a failure as a buyer
When you’re buying, past failures are evidence. They show what went wrong and, more usefully, whether it got fixed. The car’s MOT history is the record to read, and a few patterns matter more than the rest:
| Pattern in the MOT history | What it usually means | What to ask |
|---|---|---|
| Bulbs, wipers, a single tyre | Routine wear, fixed on the day | Nothing, if the retest passed |
| Corrosion advisories that grow each year | Rust left untreated; can reach structural points | Has anyone treated it? Look underneath |
| Suspension advisories, then a fail | Worn parts left until they failed | Which parts were replaced at the retest? |
| Brake fails on several tests | Maintenance done only when forced | Service invoices for the brakes |
| Engine warning light fail, then a pass | The light was cleared; was the fault? | What did the garage find and fix? |
| Fail, then no retest for months | The car sat untested; was it driven? | Check the tax status for the same months |
Watch the mileage beside each test too. A failure sheet that records a lower reading than the year before is a different kind of problem from a worn bush, and it’s worth a mileage check before you go any further.
What an MOT fail doesn’t tell you
The test is a snapshot of the parts on the list. GOV.UK is clear that engine, clutch and gearbox condition fall outside it, and that it isn’t a service. Years of clean passes don’t rule out a new clutch next month. And the MOT record never mentions lenders, write-off categories or theft markers; they live elsewhere.
Check a car’s MOT failures and advisories by reg
Everything in the DVSA record, sorted by date, is free to read from the reg on our site:
- MOT history check: each fail, defect and advisory with the date and mileage
- Mileage check: the MOT readings lined up, with any drop flagged
- Car history check: the MOT record here; lender, write-off and theft data sit in the full report
- Car write-off check: whether repeated body fails trace back to an insurance write-off
- What is an MOT?: what the test covers, the fee and the retest rules
- Can you drive without an MOT?: which journeys a failed car may make
Common MOT failure questions
What is the most common MOT failure?
In the DVSA’s 2025-26 figures for cars and light vans, lamps, reflectors and electrical equipment had the highest share, with a defect recorded in 10.44% of tests. Suspension came next at 8.90%.
What percentage of cars fail their MOT?
27.51% of tests on cars and light vans failed first time in the 2025-26 data, and 22.30% had a fail as the final result, according to the DVSA data set.
Can a blown bulb fail an MOT?
Yes. A dead number plate lamp is a major defect when the plate has only one lamp, and headlamp aim outside the limits is major too. If the rear plate has two or more lamps, one dead lamp is only minor.
What’s the legal tyre tread depth for an MOT?
At least 1.6mm across the central three-quarters of the tread and around the whole tyre, for cars with up to eight passenger seats. Below that is a dangerous defect.
Will the engine warning light fail an MOT?
On petrol and hybrid cars first used from 1 July 2003, yes, if it stays on or never comes on. It’s graded as a major defect.
Does a chipped windscreen fail the MOT?
It can. The tester checks the screen’s condition and the driver’s view of the road. The exact size limits are in the DVSA inspection manual; GOV.UK’s short list doesn’t state them.
Can I read a car’s MOT fail reasons before buying?
Yes. The MOT history check lists every fail with the tester’s reasons, along with advisories and the mileage at each test.
Looking at a car with a few fails in its past? Put the reg into our MOT history check and see whether each one was put right.